Development of Low-NOx Combustor of Micro Gas Turbine Firing Ammonia Gas

Presented on October 31, 2018 during the NH3 Fuel Conference 2018

Authors Osamu Kurata Norihiko Iki Takahiro Inoue Takayuki Matsunuma National Institute of Advanced Industrial Science and Technology (AIST)

Download this Presentation Download a PDF version of this presentation.

Abstract

A massive influx of renewable energy is required in order to mitigate global warming. Although hydrogen is a renewable media, its storage and transportation in large quantity is difficult. Ammonia, however, is a hydrogen energy carrier, and its storage and transportation technology is already established. Although ammonia fuel combustion was studied in the 1960s in the USA, the development of an ammonia fuel gas turbine had been abandoned because combustion efficiency was unacceptably low [1]. Recent demand for hydrogen energy carrier revives the usage of ammonia fuel. The National Institute of Advanced Industrial Science and Technology (AIST) in Japan, in collaboration with Tohoku University successfully realized ammonia-kerosene gas turbine power generation in 2014, and ammonia fuel gas turbine power generation in 2015 by using 50-kWe class gas turbine [2, 3].

The drawback of the facility is that it requires a large-size selective catalytic reduction (SCR) to decrease the high concentrations of NOx. In order to promote the widespread of ammonia combustion gas turbine system, it is necessary to downsize SCR NOx reduction. In other words, it is important to reduce NOx emission from ammonia gas turbine combustor. AIST has begun developing low-NOx combustors by using a combustor test rig. Simultaneously, fundamental research was carried out at Tohoku Univ. It was found at Tohoku Univ. that rich-lean two-stage combustion method and a control of equivalence ratio of the primary combustion zone to around the value of 1.1 to 1.2 significantly decreases NO emissions in gas-turbine swirl combustor [4, 5].

Based on the knowledge of rich-lean combustion method, the flow paths of the combustor in the combustor rig tests were systematically varied to make a fuel rich region in the primary combustion zone. First, NOx emissions of standard combustor was measured in the range of fuel input energy of 140 to 330 kJ/s where NH3 fuel input energy of 236 kJ/s was over the limit that can be supplied by an NH3 fuel supply facility. Although, input energy over 236 kJ/s was supplied by CH4 fuel, it was shown in the previous study [3] that the addition of NH3 in the CH4+NH3 mixture increased the NO emissions for the most part. NO emission of standard combustor was flat 1000 (16% O2) ppm from 140 to 330 kJ/s of CH4+NH3 fuel input energy. Next, NOx emissions of the modified combustors were measured. The modifications applied to the combustor included filling the primary dilution holes by using stainless bolts, opening the secondary dilution holes by drilling, and halving the air swirler area by using stainless hook or stainless wire reel. These modifications were intended to increase the equivalence ratio of primary combustion zone. Valley of NO emissions of the modified combustor was observed in the range of fuel input energy of 140 to 236 kJ/s, which implied the ability of low-NOx gas turbine combustion firing ammonia gas.

Acknowledgements
This work was supported by the Council for Science, Technology and Innovation (CSTI), the Cross-ministerial Strategic Innovation Promotion Program (SIP), “Energy Carriers” (Funding agency: Japan Science and Technology Agency (JST)).

References
[1] Pratt, D.T., Performance of Ammonia-fired Gas-turbine Combustors, Technical Report No.9, DA-04-200-AMC-791(x), Berkley University of California (1967), available at http://www.dtic.mil/dtic/tr/fulltext/u2/657585.pdf.
[2] Iki, N., Kurata, O., Matsunuma, T., Inoue, T., Suzuki, M., Tsujimura, T., Furutani, H., Kobayashi, H., Hayakawa, A., Arakawa, Y., Ichikawa, A., Micro Gas Turbine Firing Ammonia, The 12th Annual NH3 Fuel Conference, Chicago, September 20-23, (2015), available at https://nh3fuelassociation.org/conference2015.
[3] Kurata, O., Iki, N., Matsunuma, T., Inoue, T., Tsujimura, T., Furutani, H., Kobayashi, H., Hayakawa, A., Performances and Emission Characteristics of NH3-air and NH3-CH4-air Combustion Gas-turbine Power Generations, Proc. Combust. Inst., 36 (2017) 3351-3359.
[4] A. Hayakawa, Y. Arakawa, R. Mimoto, K. D. Kunkuma A. Somarathne, T. Kudo, H. Kobayashi, Int. J. Hydrogen Energy, 42 (2017) 14010–14018.
[5] K. D. Kunkuma A. Somarathne, S. Hatakeyama, A. Hayakawa, H. Kobayashi, Int. J. Hydrogen Energy, 42 (2017) 27388–27399.

Topics Ammonia Combustion Ammonia Gas Turbine Dual Fuel Emissions Testing NOx Emissions

Authors osamu.kurata@aist.go.jp n-iki@aist.go.jp t-inoue@aist.go.jp t-matsunuma@aist.go.jp tsujimura-taku@aist.go.jp furutani.h@aist.go.jp masato_kawano@toyota-energy.co.jp keisuke_arai@toyota-energy.co.jp ekenechukwu.okafor@aist.go.jp hayakawa@flame.ifs.tohoku.ac.jp kobayashi@ifs.tohoku.ac.jp

Madoqua Power2X webinar on Tuesday, November 26

Please join us for this informative webinar. Click here to register and get the details!

Annual Conference highlights industry advancements

It was an exciting three days in New Orleans with 300 attendees from 22 countries participating in our 21st AEA Annual Conference. Thank you to our generous sponsors and to all those who attended the conference. Stay tuned for a recap of the events and sessions. Presentations from all the sessions will be posted shortly.

Featured content

In 2023, AEA reached many milestones. Read about them in our 2023 Annual Report.